Filter
Top Products
42 ST1000 Plus & ST2000 Plus Tiller Pilots - Owner’s Handbook
4 Installing the Tiller Pilot
3. Refer to the table to establish a cutting length for the cantilever
rod – double check measurements before cutting.
4. Measure the rod from threaded end, then cut the cantilever rod
to length L using a hacksaw. Remove any sharp edges with a file.
Mounting the cantilever assembly
To mount the cantilever assembly:
1. Temporarily assemble the cantilever by screwing the rod into the
mounting ring.
2. Ensure the tiller pilot is horizontal and then mark the location of
the mounting ring and its mounting holes.
3. Drill three 6 mm (
1
/
4
in) diameter holes at the positions you have
marked.
4. Bed the mounting ring on a thin coat of silicon sealant.
Dimension F Cut length L
654 mm (25.75 in) 51 mm (2 in)
705 mm (27.75 in) 102 mm (4 in)
743 mm (29.75 in) 152 mm (6 in)
806 mm (31.75 in) 203 mm (8 in)
832 mm (32.75 in) 229 mm (9 in)
D3196-2
F
L
81130_3.book Page 42 Wednesday, July 25, 2001 11:57 AM