Filter
Top Products
Page 75GX3000E
11.4 MANUAL INPUTTING OF THE GPS LOCATION
(
LAT/LON
)
You may send the Latitude/Longitude of your vessel manually from the RAM+
Mic even if the GX3000E is not connected the GPS receiver unit.
After the position is entered, transmitting a DSC Distress, Position Request, or
Position Send will contain the manually entered position.
1. Press and hold down the
[
CALL
(
ENT
)]
key until “
RadioRadio
RadioRadio
Radio
SetupSetup
SetupSetup
Setup
” menu appears.
2. Press the
[
T
]
key to select “
DSC SETUPDSC SETUP
DSC SETUPDSC SETUP
DSC SETUP” menu.
3. Press the
[
CALL
(
ENT
)]
key, then select “
POS INPUTPOS INPUT
POS INPUTPOS INPUT
POS INPUT” with
the
[
S
]
/
[
T
]
key.
4. Press the
[
CALL
(
ENT
)]
key then, enter the your local time
by the 24-hour system on the UTC time. Use the
[
CALL
(
ENT
)]
and
[
H/L
]
key to navigate to each column of
the time, then use the
[
S
]
/
[
T
]
key to select the desired num-
bers in colum. Repeat for each colum, to completed the time.
5. Enter the Latitude/Longitude of your vessel location with the
same procedure as description above.
6. Press and hold in the
[
ENT
]
key to store the data entered,
then press the
[
16/9
]
key to exit this menu and return to
radio operation mode.