Filter
Top Products
TASCAM DR-100MKII
13
2 – Names and Functions of Parts
r
PLAY/PAUSE [
y
/
9
] button
When the Home Screen is displayed and playback is
stopped, press this button to start playback.
During playback, press this button to pause.
When a le or folder is selected in the
BROWSE
screen,
press this button to return to the Home Screen and play
the le or the rst le in the folder from the beginning.
t
PB CONTROL button
Use to open and close the
PB CONTROL
screen and to
turn its functions ON and OFF. (See “Special playback
control functions” on page 45.)
y
INPUT switch
Set to the desired input signal source.
u
Wheel
Use this to select items and change values on setting
screens.
Use it also to change the playback position in a track.
i
ENTER/MARK button
Use this to conrm the selection of a setting item or to
answer “YES” to a conrmation message.
During recording or playback, press this button to add
a mark manually.
While pressing this button, press the STOP [8] button
to clear the nearest mark earlier in the le.
Press the . or / button while pressing and
holding this button to move to the previous or next
mark, respectively. (See “Mark function” on page 36.)
o
AUTO button
Use this to make various settings for the automatic
recording function and to enable it. (See “Automatic
recording (AUTO REC)” on page 35.)
p
RECORD [
0
] button/indicator
Press this button when stopped to start recording
standby. The recording indicator will blink when in
standby.
Press this button when in recording standby to start
recording. The recording indicator will light when
recording.
Press this button when recording to pause recording.
Front panel
a
XLR (MIC/LINE 1) IN L/R connectors
These are balanced XLR connectors for analog inputs.
(1: GND, 2: HOT, 3: COLD)
CAUTION
Confirm that phantom power is OFF before connecting
•
a line level device to a XLR (MIC/LINE 1) IN connector.
If you connect a line level device while phantom power
is being supplied, that device and this unit could be
damaged.
When using a condenser microphone, before
•
connecting to and disconnecting from a XLR (MIC/
LINE 1) IN connector, confirm that the phantom power
for that connector is OFF. If you connect or disconnect
a mic while phantom power is being supplied, that mic
and this unit could be damaged.
Do not connect an unbalanced dynamic mic to an XLR
•
connector when phantom power is being supplied.
Doing so could damage that mic and this unit.
s
MIC/LINE 1 switch
Use this to set the input type of the XLR (MIC/LINE 1)
IN connector.
Rear panel
d Directional stereo mic pair (UNI MIC L/R)
These are built-in electret condenser stereo mics.
f SD card slot
Insert and remove SD cards.