Filter
Top Products
TASCAM DR-100MKII
37
Moving to a mark position
You can move to marks in the currently selected le when
paused and during playback.
You can use this function to identify points to create
shortcuts to the beginning of songs, for example.
Press the .// buttons while pressing and
holding the ENTER/MARK button during playback or
when stopped.
NOTE
You cannot move to a mark in a dierent le.
Clearing Marks
While pressing the ENTER/MARK button press the STOP
[8] button to clear the nearest mark earlier in the le.
When you clear a mark, its number appears in a popup at
the bottom of the screen.
Recording the moment before
pushing RECORD (PRE REC)
By using prerecording, when the unit is in recording
standby you can record up to two seconds of the signal
input before the RECORD [0] button is pushed to start
recording.
1 Press the MENU button to open the
MENU
screen.
2 Use the wheel to select
REC SETTING
, and press the
ENTER/MARK button.
The
REC SETTING
screen appears.
3 Use the wheel to select the PRE REC item and press
the / or ENTER/MARK button.
4 Use the wheel to set the
PRE REC
item to
ON
.
TIP
By using this in combination with the auto-record function,
you can record events without losing the beginnings of
sounds.
NOTE
If the amount of time in record standby is less than two
•
seconds, the sound for that amount of time is recorded.
You cannot use the PRE REC function with overdub
•
recording. When overdubbing set the PRE REC item OFF.
When you turn the prerecording function ON, you
•
should turn the record delay function OFF. If both are
ON, only prerecording will function.
Delaying the start of recording (REC
DELAY)
This function allows you to delay the start of recording by
0.3 seconds (xed interval) after the RECORD [0] button
is pressed.
This is useful when you want to avoid recording the sound
of pressing the RECORD [0] button.
1 Press the MENU button to open the
MENU
screen.
2 Use the wheel to select the
REC SETTING
menu item,
and press the ENTER/MARK button.
3 Use the wheel to select the DELAY item, and press
the / or ENTER/MARK button.
4 Use the wheel to set the
DELAY
item to
ON
.
NOTE
Set
PRE REC
to
OFF
when you set
REC DELAY
to
ON
.
4 – Recording