Step 3:
When
insert
side 2
appears,
turn the
Check Strip
over and
with Side 2
(white)
facing up,
insert it
back into the Test Strip
Holder, notched end first.
The Meter counts down
from 4 to 0, then
A 3 .9
A ok
(example)
appears if the number falls
within the acceptable Check
Strip range. The Meter
automatically tells you if
the reading falls within the
correct Check Strip range.
The range is also printed on
the back of the Meter in
both mmol/L and mg/dL.
You may now proceed with
a blood glucose test. These
messages will continue to
display until the Meter is
turned off, or for 2 minutes,
when the Meter automa-
tically turns off.
If the reading is not within
the acceptable Check Strip
range, the Meter display
will read
A 2 . 1
Anotok
redo A
(example)
Go back to Step 1 and
repeat the Check Strip test.
If this message appears
again, clean your Meter by
following the steps in
2
✔
side 2
• 16 •
LSI-97-051 OT2.bklt.C.Eg 10/8/97 3:10 PM Page 16 (1,1)
