A SERVICE OF

logo

error1
retest
appears if the sample was
applied before apply
sample appeared on the
display. (See Chapter 6,
Testing Your Blood.)
error2
retest
appears if you made a
mistake in the test
procedure or if there is a
problem with the Meter.
(See Chapter 7,
Troubleshooting.)
not
enough
blood
retest
appears if your blood or
Control Solution sample
was too small or smeared.
(See Check the Amount of
Blood on the Test Strip in
Chapter 6, Testing Your
Blood.)
mm 7 . 5
event6
(example)
will appear alternating back
and forth when you select
an Event marker. (For
further information see
Selecting Event Numbers in
Chapter 10, Recalling Tests
from Meter Memory.)
apply
apply
apply
When the battery is getting
low, display messages flash
continuously. The Meter
will still provide accurate
test results. (See Battery
Replacement in Chapter 8,
Cleaning and Maintaining
the Meter.)
70
LSI-97-051 OT2.bklt.C.Eg 10/8/97 3:10 PM Page 70 (1,1)