Recalling Tests from Meter
Memory.)
battry
appears when the battery is
too low to perform another
test. (See Battery Replace-
ment in Chapter 8, Cleaning
and Maintaining the Meter.)
clean
test
area
appears when the Meter
detects that there is dirt,
lint, or blood on the Test
Area, indicating that it must
be cleaned. (See Chapter 8,
Cleaning and Maintaining
the Meter.) This message
may also appear if your
hand or any other surface is
placed above the Test Area
immediately after the Meter
is turned on; or if the Test
Strip is partially or fully
inserted before insert
strip appears. (See Chapter
6, Testing Your Blood.)
code 9
(example)
appears when the Meter is
first turned on. The code
number is between 1 and
16, and must match the
code number on the Test
Strip package to ensure
accurate results. (See
Chapter 4, Coding the
Meter.)
c 5 .4
contrl
(example)
appears when a Glucose
Control Solution test is
performed. This message
may also appear after a
blood test if the sample was
too small. (See Check the
Amount of Blood on the
Test Strip in Chapter 6,
Testing Your Blood.)
• 69 •
LSI-97-051 OT2.bklt.C.Eg 10/8/97 3:10 PM Page 69 (1,1)
