A SERVICE OF

logo

Open as PDF
next previous
it is pushed back to its
original position as quickly
as possible.
ٗ
✔
Do not smear the blood
on the Test Spot or apply a
second drop after the test
has begun.
ٗ
✔
Do not remove the Test
Strip from the Meter to
apply blood.
ٗ
✔
Touch only the tip of the
drop of blood to the Test
Strip.
The Meter will beep when it
detects that a sample of
blood has been applied to
the Test Spot.
2. The Meter
then counts
down from
45 to 0
seconds, and
you will
hear a series
of beeps
when your
result is
displayed.
mm 5 . 9
(example)
Be sure to wait for the beeps
before you note your result.
The Meter reads results
which are between 0 and
33.3 mmol/L, indicated
CAUTION: Always check
that “MM” and a decimal
point (or comma) are
displayed with your
blood glucose result. If
not, you may have
accidentally changed the
unit of measurement to
mg/dL, or an electronic
malfunction may have
occurred. (See Chapter 9,
Setting Date, Time, and
Other Special Functions,
to reset the unit of
measurement to mmol/L).
mm 5.9
• 31 •
LSI-97-051 OT2.bklt.C.Eg 10/8/97 3:10 PM Page 31 (1,1)