Chapter 5 WAN Setup
P-2812HNU-51c User’s Guide
107
5.5.1 Internet Connection Configuration
Click the Edit or Add button in the WAN Service screen to configure a WAN
connection.
Rate This shows the maximum data rate (in Kbps) allowed for traffic sent
through this connection. This displays N/A when there is no limit on
transmission rate.
Vlan8021p This indicates the 802.1P priority level assigned to traffic sent through
this connection. This displays N/A when there is no priority level
assigned.
VlanMuxId This indicates the VLAN ID number assigned to traffic sent through
this connection. This displays N/A when there is no VLAN ID number
assigned.
ConnId This shows the index number of each connection. This displays N/A
when the interface used by the connection is in Default Mode.
IGMP This shows whether IGMP (Internet Group Multicast Protocol) is
activated or not for this connection. IGMP is not available when the
connection uses the bridging service.
NAT This shows whether NAT is activated or not for this connection. NAT is
not available when the connection uses the bridging service.
Firewall This shows whether the firewall is activated or not for this connection.
The firewall is not available when the connection uses the bridging
service.
IPv6 This shows whether IPv6 is activated or not for this connection. IPv6
is not available when the connection uses the bridging service.
MLD This shows whether Multicast Listener Discovery (MLD) is activated or
not for this connection. MLD is not available when the connection uses
the bridging service.
Modify Click the Edit icon to configure the WAN connection.
Click the Remove icon to delete the WAN connection.
Add Click Add to create a new connection.
Table 20 Internet Connection (continued)
LABEL DESCRIPTION
