Chapter 5 WAN Setup
P-2812HNU-51c User’s Guide
110
5.5.1.3 WAN IP Address and DNS Server
The screen differs by the encapsulation you selected in the previous screen. See
Section 5.7 on page 125 for more information.
Rate Limit Enter the maximum transmission rate in Kbps for traffic sent through the
WAN connection. Otherwise, leave this field blank to disable the rate
limit.
This field is not available for an ATM connection.
Tag VLAN ID
for egress
packets
Select this option to add the VLAN tag (specified below) to the outgoing
traffic through this connection.
This field is available when the layer-2 interface is in VLANMUX mode.
Enter 802.1P
Priority
IEEE 802.1p defines up to 8 separate traffic types by inserting a tag into
a MAC-layer frame that contains bits to define class of service.
Type the IEEE 802.1p priority level (from 0 to 7) to add to traffic through
this connection. The greater the number, the higher the priority level.
This field is available when the layer-2 interface is in VLANMUX mode.
Enter 802.1Q
VLAN ID
Type the VLAN ID number (from 1 to 4094) for traffic through this
connection.
This field is available when the PTM interface is in VLANMUX mode.
Enable IPv6 for
this service
Select this option to enable IPv6 for this WAN service so that the P-
2812HNU-51c can use an IPv6 address when sending traffic through this
connection.
You can only enable IPv6 for a WAN service that uses the PPPoE or IPoE
encapsulation method over the ATM or PTM interface.
Back Click this button to return to the previous screen.
Next Click this button to continue.
Table 22 WAN Configuration: Service Type
LABEL DESCRIPTION
