Chapter 19 Quality of Service (QoS)
P-2812HNU-51c User’s Guide
319
19.6 The QoS Policer Setup Screen
Use this screen to configure QoS policers that allow you to limit the transmission
rate of incoming traffic. Click Advanced > QoS > Policer Setup. The screen
appears as shown.
Figure 163 QoS > Policer Setup
The following table describes the labels in this screen.
Table 106 QoS > Policer Setup
LABEL DESCRIPTION
Add Click this button to create a new entry.
No. This is the index number of this entry.
Active Select the check box to enable the policer.
Name This field displays the descriptive name of this policer.
Regulated
Classes
This field displays the name of a QoS classifier
Meter Type This field displays the type of QoS metering algorithm used in this
policer.
Parameter This field displays the parameters configured for the metering
algorithm in the policer.
Action This field displays the actions taken on the matched traffic.
Modify Click the Edit icon to go to the screen where you can edit the policer.
Click the Remove icon to delete an existing policer. Note that
subsequent rules move up by one when you take this action.
Apply Click Apply to save your changes back to the P-2812HNU-51c.
