Filter
Top Products
-42-
Programmingoftheindicatorisdividedintomodularsteps.Eachmoduleisa
short sequence of data entries. The front panel buttons “UP” and “DOWN”
(shownas“arrows”onthefrontpanel)areusedtochangethedataandset-ups,
while the “P” button is used to save or enter the data. After pressing “P”,
which gainsentry into theprogramming mode, theprogramming modules are
identified by the message “Pro” and a number in the display. “UP” and
“DOWN” are usedto selectthe desired programming module and“P” isused
toenterit.Allofthesubsequentprogrammingstepsfollowthesameprocedure.
The rear terminallabeled “PGM. DIS.” mustbe ungrounded to gainaccess to
programming. The following table lists the programming steps.
“Pro 0” - RETURN TO MEASUREMENT MODE
“Pro 1” - PROGRAM THERMISTOR TYPE, TEMPERATURE SCALE
AND DECIMAL POINT POSITON
“tYPE” - Select thermistor type (400/700)
“SCALE” - Enter either degree (F or C)
“dECPNt” - Enter resolution (0 or 0.0)
“Pro 2” - PROGRAM TEMPERATURE SLOPE AND OFFSET
“SLOPE” - Enter display slope (0.0001 to 9.9999)
“OFFSEt” - Enter offset (-999 to 9999)
“Pro 3” - PROGRAM FUNCTIONS ACCESSIBLE WITH FRONT
PANEL LOCKOUT ENGAGED
“dSP AL” - Enable display alarms
“ENt AL” - Enable enter alarms =
“dSPHYS” - Enable display hysteresis
“ENtHYS” - Enable enter hysteresis =
“rSt AL” - Enable reset latched alarms
“dSPbUF” - Enable display of peak/valley readings
“rStbUF” - Enable reset of peak/valley readings=
“SELdSP” - Enable switching display between input and total
“rSttOt” - Enable reset total
“dSPOFF” - Enable display offset value
“ENtOFF” - Enable enter offset value =
“Pro 4” - PROGRAM DIGITAL FILTERING AND REMOTE
INPUT FUNCTION
“FILter” - Enter level of digital filtering
0 - no digital filtering
1 - normal filtering
2 - increased filtering
3 - maximum filtering
“E1-CON” - Enter function of remote input
0 - offset input to zero
1 - reset total
2 - reset and gate totalizer
3 - gate totalizer
4 - display hold
5 - reset peak/valley
6 - reset peak and start peak indicator
7 - reset valley and start valley indicator
8 - reset latched alarms
9 - reset all alarms
10 - toggle display between input and total
11 - offset input to zero and totalizer the offset values
12 - display hold with tare
13 - instrument reading with synchronization
14 - print request
“E2-CON” - same functions as E1-CON
APPENDIX “D” - PROGRAMMABLE FUNCTIONS
= This sequence may be subject to being locked-out due to other programmed
sequences.