Filter
Top Products
-43-
“Pro 5” - PROGRAM INTEGRATOR/TOTALIZER
“dECPNt”
-
Enter decimal point for totalizer
“tbASE”
-
Enter time base
0
-
second
1
-
minute
2
-
hour
“SCLFAC”
-
Enter multiplying scale factor
“Lo-cut”
-
Enter low-signal cut out
“Pro 6” - PROGRAM ALARMS
“trAc”
-
Enable alarm value tracking
“dISP”
-
Enable display alarm annunciators
“LAtC-1”
-
Enable alarm #1 latching
“ASN-1”
-
Enter alarm #1 trigger source ( temp. or integrator/ total)
“AL-1”
-
Enter alarm #1 value
“HYS-1”
-
Enter hysteresis value for alarm #1
“Act-1”
-
Enter alarm #1 action (high or low)
“LAtC-2”
-
Enable alarm #2 latching
“ASN-2”
-
Enter alarm #2 trigger source ( temp. or integrator/ total)
“AL-2”
-
Enter alarm #2 value
“HYS-2”
-
Enter hysteresis value for alarm #2
“Act-2”
-
Enter alarm #2 action (high or low)
“Pro 7” - PROGRAM SERIAL COMMUNICATIONS
“bAud”
-
Enter baud rate
“AddrES”
-
Enter loop address number (0-99)
“Print”
-
Enter print function, or “P” command function through
Serial Option
0
-
temp.
1
-
temp., peak/valley, and offset
2
-
temp. and alarms
3
-
temp, peak/valley, alarms, hysteresis, and offset
4
-
total
5
-
temp. and total
6
-
temp., total, peak/valley, and offset
7
-
total and alarms
8
-
temp., total and alarms
9
-
temp., total, peak/valley, alarms, hysteresis, and offset
“FULL”
-
Enable complete or abbreviated printing
“Pro 8” - PROGRAM RE-TRANSMITTED ANALOG OUTPUT
“ASIN”
-
Select source of analog output (input or total)
“AN-Lo”
-
Enter 4 mA or 0 VDC display value
“AN-HI”
-
Enter 20 mA or 10 VDC display value
“Pro 9” - SERVICE OPERATIONS (Protectedby access codes)
“Code 39”
-
Serial hardware (loop-back) test
“Code 48”
-
Basic input calibration
“Code 66”
-
Reset programming to factory configuration
APPENDIX “D” - PROGRAMMABLE FUNCTIONS (Cont’d)