Filter
Top Products
Cisco Support Tools 1.0 User Guide How to Use the Registry Utility from a Command Line 134
How to Use the Registry Utility from a Command Line
While primarily designed for use from the Support Tools Dashboard, the Registry
utility can also be run from a command line any node, as desired.
Use the Registry utility to:
• View the ICM Windows registry settings for the current system
• Save registry settings to a file
To Run the Registry Utility from a Command Line
To run the Registry utility in interactive mode from a command line:
1. From a command prompt on a Support Tools node, navigate to
<support_tools_root>.
2. Enter registry. Optionally in the same line, to specify a different machine to
serve as the application server, enter its DNS or IP address. If none is specified,
the local machine serves as the application server. Press <Enter>.
To view a list of systems defined in the current system's system list, use the
systemlist command. To view connection status for systems in the list, use
the systemlist /check command.
3. Enter commands as described in the Command Line Options section below.
Note: For additional information on basic Web Tools command line use, including
system selection options and command-line mode vs interactive mode see About
Using Cisco Web Utilities from a Command Line.