Filter
Top Products
Figure 13. Replacing an SD card
1. IDSDM card 2. SD card
3. upper card slot (SD 2) 4. lower card slot (SD 1)
Next steps
1. Follow the procedure listed in After working inside your system.
2. Enter the System Setup and ensure that the Internal SD Card Port and Internal SD Card
Redundancy mode is enabled.
3. Check if the new SD card is functioning properly. If the problem persists, see Getting Help.
Internal USB key
The sled provides an internal USB connector for a USB flash memory key. The USB memory key can be
used as a boot device, security key, or mass storage device. To use the internal USB connector, the
Internal USB Port option must be enabled in the Integrated Devices screen of the System Setup.
To boot from the USB memory key, you must configure the USB memory key with a boot image, and
then specify the USB memory key in the boot sequence in the System Setup. For information on creating
55