Filter
Top Products
3. Remove the hard-drive/SSD cage. See Removing the hard-drive/SSD cage.
4. Loosen the two retention screws securing the hard-drive/SSD backplane cable connector to the
system board connector.
5. Lift the backplane up and away from the system.
Figure 31. Removing and installing the hard-drive/SSD backplane
1. hard-drive/SSD backplane 2. hard-drive/SSD backplane cable
3. retention screw (2) 4. screw hole on the hard-drive/SSD cage
(2)
5. guide pin 6. retention screw on the hard-drive/SSD
backplane cable connector (2)
7. connector
Next steps
1. Install the hard-drive/SSD backplane, see Installing the hard-drive/SSD backplane.
2. Install the hard drive/SSD.
3. Follow the procedure listed in After working inside your system.
Related Links
Removing a hard drive/SSD
80