Filter
Top Products
Quick Start Guide
15
June 2014
Figure 11. Basic Configuration Menu Tree
Before you begin
See Figure 10 to graphically view the step by step process for basic device
configuration. Before beginning configuration you may need to verify the Device
Tag or deactivate hardware and software write protection on the transmitter. To
do this follow Step 1 through Step 3 below. Otherwise continue at “AI block
configuration” below.
1. To verify the device tag:
a. Navigation: from the overview screen, select “Device Information” to verify
the device tag.
2. To check the switches (see
Figure 8):
a. The write lock switch must be in the unlocked position if the switch has
been enabled in software.
3. To disable the Software Write Lock:
(Overview)
Pressure
Calibration
Device Information
Locate Device
Scale Gauges
(Calibration)
Primary Value
Sensor Trim
Sensor Limits
Restore Factory Calibration
Last Calibration Points
Calibration Details
(Device Information)
Identification (1)
Revisions
Materials of Construction
License
Security & Simulation
(Materials of Construction)
Sensor
Sensor Range
Flange
Remote Seal
(Configure)
Guided Setup
Manual Setup
Alert Setup
(Manual Setup)
Process Variable
Materials of Construction
Analog Input Blocks Configuration
Display
(Display )
Display Options (8, 9)
Advanced Configuration
(Classic View ) (9)
View All Parameters
Mode Summary
AI Blocks Channel Mapping
Master Reset
(Process Variable )
Pressure
Pressure Damping
Sensor Temperature
Configure Analog Input Blocks (3, 4, 5, 6, 9)
Change Damping (8, 10)
(Security & Simulation)
Write Lock Setup (2, 10)
(Guided Setup)
Zero Trim
Change Damping (7, 9)
Local Display Setup (8, 9)
Configure Analog Input Blocks (3, 4, 5, 6)
Standard Text – Navigation selections available
(Text) – Name of selection used on parent menu screen to access this screen
Bold Text – Automated methods
Underlined Text -- Configuration task numbers from configuration flow chart
Classic View
00825-0100-4774_RevFA.fm Page 15 Friday, June 6, 2014 2:21 PM