Filter
Top Products
June 2014
2
Quick Start Guide
NOTICE
This installation guide provides basic guidelines for Rosemount 3051 transmitters. It does not
provide instructions for configuration, diagnostics, maintenance, service, troubleshooting,
Explosion-Proof, Flame-Proof, or intrinsically safe (I.S.) installations. Refer to the 3051 reference
manual (document number 00809-0100-4774) for more instruction. This manual is also
available electronically on www.emersonprocess.com/rosemount.
Explosions could result in death or serious injury.
Installation of this transmitter in an explosive environment must be in accordance with the
appropriate local, national, and international standards, codes, and practices. Please review the
approvals section of the 3051 reference manual for any restrictions associated with a safe
installation.
In an Explosion-proof/Flameproof installation, do not remove the transmitter covers when
power is applied to the unit.
Process leaks may cause harm or result in death.
To avoid process leaks, only use the o-ring designed to seal with the corresponding flange
adapter.
Electrical shock can result in death or serious injury.
Avoid contact with the leads and the terminals. High voltage that may be present on leads can
cause electrical shock.
Conduit/cable entries
Unless marked, the conduit/cable entries in the transmitter housing use a
1
/2-14 NPT thread
form. Only use plugs, adapters, glands, or conduit with a compatible thread form when
closing these entries.
Contents
System readiness . . . . . . . . . . . . . . . page 3
Confirm correct device driver . . . . page 3
Transmitter installation . . . . . . . . . page 5
Tagging . . . . . . . . . . . . . . . . . . . . . . . page 9
Housing rotation . . . . . . . . . . . . . . page 10
Set the switches . . . . . . . . . . . . . . .page 11
Wire, ground, and power up . . . . . page 12
Configure . . . . . . . . . . . . . . . . . . . . . page 14
Zero trim the transmitter . . . . . . .page 20
Product Certifications . . . . . . . . . . page 21
00825-0100-4774_RevFA.fm Page 2 Friday, June 6, 2014 2:21 PM