Filter
Top Products
1. OPERATIONAL OVERVIEW
1-2
SD cards
The SD cards store ship’s tracks, routes, points, settings, etc. The unit
accepts SD and SDHC (Secure Digital High Capacity) type cards and
the maximum capacity is 32 GB.
To set a card in the slot, insert the card label side up. If the card does not go in easily,
do not use force. Push the card until the card is in position.
To remove a card, Select [Eject SD card] from the full RotoKey menu.
Remove the card (with your fingers) after the message "You can eject SD card safely."
appears.
Care and handling of SD cards
• Handle the cards carefully; rough handling can damage the card and destroy its
contents.
• Make sure the cover is closed at all times. Insert the card fully or remove the
card; the cover cannot be closed if the card is inserted partially.
• Remove a card with only your fingers. Do not use metal instruments (like tweezers)
to remove the card.
• Do not remove a card during the reading of the card or writing to the card, to prevent
damage to the card and loss of the data stored on the card.
• If water is at the bottom of the cover, DO NOT open the cover. Remove the water
with a dry cloth completely and then open the cover.
RotoKey
TM
Short push: Display the base RotoKey soft controls for the current
mode.
Long push: Display the full RotoKey soft controls for the current mode.
Rotate: Zoom in or out the display range for the chart. Select a menu
item. Select the display range for the fish finder.
POINTS/GO
TO key
Short press: Put a point at the cursor position.
Long press: Set cursor position as destination.
EVENT/
MOB key
Short press: Put a point at the current position.
Long press: Put an MOB (ManOverBoard) mark at current position.
ENT key Confirm current operation.
ESC/MENU
key
Short press: Escape from current operation. Silence an audio alarm.
Long press: Open the menu.
HOME/
CTRL key
Short press: DIsplay the home screen, to select a display.
Long press: Switch the active display in combination modes.
CursorPad Moves the cursor and scrolls the screen, in the direction of the arrow
pressed.
SD card slot: Card drive for SD card (chart card and memory card).
Micro USB connector: Connects to a PC for maintenance. (Mouse or USB flash mem-
ory cannot be connected.)
RESET button: Resets the program. Should the screen freeze press this button to re-
start.
Control Description