Filter
Top Products
3
Operation panel
1
1.2.2 Basic operation (factory setting)
Automatic
parameter setting
STOP
Operation mode switchover
Parameter settingFaults history Monitor/speed setting
At powering ON (External operation mode)
PU operation mode
(Rotation speed monitor)
Parameter setting mode
PU Jog operation mode
Output current monitor
Output voltage monitor
Display the
present setting
Value change
Value change
Parameter write is completed!!
Parameter and a setting value
flicker alternately.
Parameter clear All parameter
clear
Faults history clear
Initial value
change list
(Example)
(Example)
The speed setting has been
written and completed!!
and the speed flicker alternately.
[Operation for displaying faults history]
The past eight faults can be displayed using the setting dial.
(The latest fault is ended by ".".)
When no fault history exists, is displayed.
While a fault is displayed:
The display shifts as follows by pressing : Rotation speed at the fault
Output current Output voltage Energization time.
(After Energization time, it goes back to a fault display.)
Pressing the setting dial shows the fault history number.
(Refer to Chapter 4 of the Instruction manual(Applied).)
(Refer to page 4)