Filter
Top Products
- 14 -
1. Make sure the Master Reading Source is set to the Hard
Drive.
It is very important to make sure the Master Reading Source is
set to the Hard Drive in order to avoid unnecessary error
messages. To check the Master Reading Source, please do the
following:
a. Use UP or DOWN arrow button to navigate to the following
screen.
b. Press “>>” to enter Select Source Menu and you shall see
the following:
Make sure it is located at “Hard Drive”. If not, then you
need to press UP or DOWN navigation button to search for
it.
c. Press “>>” to submit your selection. After your selection
has been submitted, you will see the following:
2. Load your master disc onto the Hard Drive. If you have
already loaded your master disc onto the Hard Drive, then
you can skip step 2 and go to step 3.
Hard Drive Port 0
WDC WD400EB-75CPF0
DUPLICATOR 1.00
8. Select Source
DUPLICATOR 1.00
8. Select Source