Filter
Top Products
- 2 -
3. Temperature Warning:
If the duplicator was stored in a location where the temperature
dropped below 32°F (0°C) within the past 24 hours, please leave the
duplicator in a warm room with temperatures at least 65°F (19°C)
for 4 hours prior to powering it on for the first time. Failure to do so
may cause irreparable harm and prevent the duplicator from
functioning.
4. External Connection Warning:
If you have an external connection installed in your duplicator, you
will see the USB/Firewire sticker(s) on your writer front drive
panel(s). In order to operate the duplicator solely as a standalone
unit (no connection to the computer), you have to make sure all of
the USB/Firewire connection(s) are off. If by any chance, the
USB/Firewire connection(s) are on, please refer to “Setup Guide:
Setup IEEE USB 2.0 / 1394 Firewire device(s)”
5. Maintenance:
It is very important to operate and keep the duplicator in a dust free,
clean environment since dust is the number 1 killer for CD/DVD
recording devices. Failure to do so may severely damage your
duplicator. We strongly suggest you place an Air Cleaner next to the
duplicator and constantly use the Air Duster (Can Air) to clear off
any dust on the surface of the duplicator.
Do not try to use the Air Duster to clean the
duplicator while the reader/writer trays are open. In
doing so, you may inadvertently blow dust into the
recording device and damage the recording device.
6. Proper Shutdown:
To avoid possible system failures, you need to shutdown the
duplicator properly. To shutdown the duplicator, you need to press
“>>” button to “16. Shutdown” and follow instructions on the screen
to shutdown the duplicator properly. Turning off your duplicator
without performing this function will increase the risk of damaging