Filter
Top Products
Fabric OS Administrator’s Guide 103
53-1002745-02
Equipment status
3
4. Use the switchStatusShow command to further check the status of the switch.
Verifying High Availability features (Backbones only)
High Availability (HA) features provide maximum reliability and nondisruptive management of key
hardware and software modules.
Use the following procedure to verify High Availability features for a Backbone:
1. Connect to the switch and log in using an account with admin permissions.
2. Enter the chassisShow command to verify the model of the DCX and obtain a listing of all
field-replaceable units (FRUs).
3. Enter the haShow command to verify HA is enabled, the heartbeat is up, and that the HA state
is synchronized between the active and standby CP blades.
4. Enter the fanShow command to display the current status and speed of each fan in the system.
Refer to the hardware reference manual of your system to determine the appropriate values.
5. Enter the psShow command to display the current status of the switch power supplies. Refer to
the hardware reference manual of your system to determine the appropriate values.
6. Enter the slotShow -m command to display the inventory and the current status of each slot in
the system.
Example of the slot information displayed for a DCX chassis
DCX:FID128:admin> slotshow -m
Slot Blade Type ID Model Name Status
--------------------------------------------------
1 SW BLADE 55 FC8-32 ENABLED
2 SW BLADE 51 FC8-48 ENABLED
3 SW BLADE 39 FC8-16 ENABLED
4 SW BLADE 51 FC8-48 ENABLED
5 CORE BLADE 52 CORE8 ENABLED
6 CP BLADE 50 CP8 ENABLED
7 CP BLADE 50 CP8 ENABLED
8 CORE BLADE 52 CORE8 ENABLED
9 SW BLADE 37 FC8-16 ENABLED
10 AP BLADE 43 FS8-18 ENABLED
11 SW BLADE 55 FC8-32 ENABLED
12 AP BLADE 24 FS8-18 ENABLED
Verifying fabric connectivity
Use the following procedure to verify fabric connectivity:
1. Connect to the switch and log in using an account with admin permissions.
2. Enter the fabricShow command. This command displays a summary of all the switches in the
fabric.
The output of the fabricShow command is discussed in “Domain IDs” on page 72.