Filter
Top Products
370 Fabric OS Administrator’s Guide
53-1002745-02
Troubleshooting TI zone routing problems
12
Example displaying information about all TI zones in the defined configuration in ascending order
switch:admin> zone --show -ascending
Defined TI zone configuration:
TI Zone Name: bluezone:
Port List: 8,3; 8,5; 9,2; 9,3;
Configured Status: Deactivated / Failover-Disabled
Enabled Status: Activated / Failover-Enabled
TI Zone Name: greenzone:
Port List: 2,2; 3,3; 4,11; 5,3;
Configured Status: Activated / Failover-Enabled
Enabled Status: Activated / Failover-Enabled
TI Zone Name: purplezone:
Port List: 1,2; 1,3; 3,3; 4,5;
Configured Status: Activated / Failover-Enabled
Enabled Status: Deactivated / Failover-Enabled
Troubleshooting TI zone routing problems
Use the following procedure to generate a report of existing and potential problems with TI zones.
The report displays an error type.
• “ERROR” indicates a problem currently exists in the fabric.
• “WARNING” indicates that there is not currently a problem, given the current set of online
devices and reachable domains, but given the activated TI zone configuration, parallel
exclusive paths between a shared device and a remote domain have been detected, which
might cause a problem for devices that join the fabric later.
1. Connect to the switch and log in using an account with admin permissions.
2. Enter the zone
--showTIerrors command.
zone --showTIerrors
Here is an example report that would be generated for the illegal configuration shown in Figure 36
on page 351.
switch:admin> zone --showTIerrors
My Domain: 3
Error type: ERROR
Affected Remote Domain: 1
Affected Local Port: 8
Affected TI Zones: etiz1, etiz2
Affected Remote Ports: 1, 2, 3, 4