Filter
Top Products
Fabric OS Administrator’s Guide 331
53-1002745-02
Zone configurations
11
Deleting a zone configuration
Use the following procedure to delete a zone configuration:
1. Connect to the switch and log in using an account with admin permissions.
2. Enter the cfgDelete command, using the following syntax:
cfgdelete "cfgname"
3. Enter the cfgSave command to save the change to the defined configuration.
The cfgSave command ends and commits the current zoning transaction buffer to nonvolatile
memory. If a transaction is open on a different switch in the fabric when this command is run,
the transaction on the other switch is automatically aborted. A message displays on the other
switches to indicate that the transaction was aborted.
Example
switch:admin> cfgdelete "testcfg"
switch:admin> cfgsave
You are about to save the Defined zoning configuration. This action will only
save the changes on Defined configuration.
Do you want to save Defined zoning configuration only? (yes, y, no, n): [no] y
Abandoning zone configuration changes
• Enter the cfgTransAbort command.
When this command is executed, all changes since the last save operation (performed with the
cfgSave, cfgEnable, or cfgDisable command) are cleared.
Example assuming that the removal of a member from zone1 was done in error
switch:admin> zoneremove "zone1","3,5"
switch:admin> cfgtransabort
Viewing all zone configuration information
If you do not specify an operand when executing the cfgShow command to view zone configurations,
then all zone configuration information (both defined and effective) displays. If there is an
outstanding transaction, then the newly edited zone configuration that has not yet been saved is
displayed. If there are no outstanding transactions, then the committed zone configuration displays.
Use the following procedure to view all zone configuration information:
1. Connect to the switch and log in using an account with admin permissions.
2. Enter the cfgShow command with no operands.
Example
switch:admin> cfgshow
Defined configuration:
cfg: USA1 Blue_zone
cfg: USA_cfg Purple_zone; Blue_zone
zone: Blue_zone
1,1; array1; 1,2; array2
zone: Purple_zone
1,0; loop1