Filter
Top Products
146 Fabric OS Administrator’s Guide
53-1002745-02
The boot PROM password
5
4. Enter 2.
• If no password was previously set, the following message is displayed:
Recovery password is NOT set. Please set it now.
• If a password was previously set, the following messages is displayed:
Send the following string to Customer Support for password recovery:
afHTpyLsDo1Pz0Pk5GzhIw==
Enter the supplied recovery password.
Recovery Password:
5. Enter the recovery password (string).
The recovery string must be between 8 and 40 alphanumeric characters. A random string that
is 15 characters or longer is recommended for higher security. The firmware prompts for this
password only once. It is not necessary to remember the recovery string, because it is
displayed the next time you enter the command shell.
The following prompt is displayed:
New password:
6. Enter the boot PROM password, and then reenter it when prompted. The password must be
eight alphanumeric characters (any additional characters are not recorded). Record this
password for future use.
The new password is automatically saved.
7. Reboot the switch by typing the reset command at the prompt.
Setting the boot PROM password for a Backbone with a recovery string
This procedure applies to the Brocade DCX, DCX-4S, DCX 8510-4, and DCX 8510-8 Backbones. The
boot PROM and recovery passwords must be set for each CP blade.
1. Connect to the serial port interface on the standby CP blade, as described in “Connecting to
Fabric OS through the serial port” on page 56.
2. Connect to the active CP blade over a serial or Telnet connection and enter the haDisable
command to prevent failover during the remaining steps.
3. Reboot the standby CP blade by sliding the On/Off switch on the ejector handle of the standby
CP blade to Off, and then back to On.
4. Press Esc within four seconds after the message “Press escape within 4 seconds...” is
displayed.
The following options are available:
5. Enter 2. Take the following appropriate action based on whether you find the password was
previously set:
• If no password was previously set, the following message is displayed:
Recovery password is NOT set. Please set it now.
Option Description
1 Start system. Continues the system boot process.
2 Recovery password. Lets you set the recovery string and the boot PROM password.
3 Enter command shell. Provides access to boot parameters.