Filter
Top Products
Administration
File Management
Cisco Small Business SG200 Series 8-port Smart Switch 68
3
To configure DHCP Auto Configuration:
STEP 1 Click Administration > File Management > DHCP Auto Configuration in the
navigation window.
STEP 2 Enter the parameters:
• Auto Configuration Via DHCP—Select Enable to enable this feature on the
switch.
• Default Network Config Mode—Select Enable to have the switch
download a default configuration file named fp-net.cfg when no host-
specific file is found on the switch. See Default Network Configuration File
for details.
• Alternate TFTP Server—Specify the IP address of a TFTP server to serve
as a backup. An alternate TFTP server is used when unicast requests to the
TFTP server specified in option 66 fails three times. (The length of the string
cannot exceed 96 characters.)
• Alternate Configuration File—Specify an alternate configuration file name
to serve as a backup. If no startup configuration file identified in DHCP option
67, or if the specified file cannot be found on the TFTP server, Auto
Configuration looks for the alternate file name. (The length of the string
cannot exceed 32 characters.)
• Last Auto Configuration File Name—The configuration file name used the
last time the Auto Configuration process executed. If a different file name is
identified through DHCP, the file download process will begin.
• Current Status—The status of the Auto Configuration process. Possible
values are AutoInstall Complete or In Progress.
STEP 3 Click Apply. Your changes are saved to the Running Configuration.