Filter
Top Products
1
Cisco Small Business SG200 Series 8-port Smart Switch 8
Getting Started
This chapter provides an introduction to the web-based switch configuration
utility and includes the following topics:
• Starting the Web-Based Switch Configuration Utility
• Quick Start Device Configuration
• Window Navigation
Starting the Web-Based Switch Configuration Utility
This section describes how to navigate the web-based switch configuration utility.
Browsers have the following restrictions:
• If you are using Internet Explorer 8, open a browser window and configure
the following settings:
Click To ols > Internet Options and then select the Security tab. Select
Local Intranet and click Sites. Click Advanced and then click Add. Add the
intranet address of the switch (http://<ip-address>) to the local intranet
zone. The IP address can also be specified as the subnet IP address, so that
all addresses in the subnet are added to the local intranet zone.
• If you are using Internet Explorer 6, you cannot directly use an IPv6 address
to access the switch. You can, however, use the Domain Name System
(DNS) server to create a domain name that contains the IPv6 address, and
then use that domain name in the address bar in place of the IPv6 address.
• If you have multiple IPv6 interfaces on your management station, use the
IPv6 global address instead of IPv6 link local address to access the switch
from your browser.
• Screen resolutions at 800x600 or lower in Internet Explorer browsers and
Firefox 3.6 are not supported by the web-based switch configuration utility.