Filter
Top Products
161
Update Trail Criteria (Auto, Time, Distance)
The options are automatic, time or distance. When it's in the default
automatic mode, the unit doesn't update the plot trail while you're
traveling in a straight line. Once you deviate from a straight line, the
unit "drops" a plot point (trail waypoint) onto the trail. This conserves
plot trail points. If a plot trail uses all of the available points allotted to
it, the beginning points are taken away and placed at the end of the trail.
From the Trails Menu, press → to
TRAIL OPTIONS|ENT|↓ to UPDATE
CRITERIA. Press ↑ or ↓ to select criteria type|ENT. If you selected Time,
the Update
Rate data entry box appears on the menu. If you selected
Distance, the Update Distance data entry box appears on the menu.
Trail Update Rate (Time, Distance)
You can update a trail by time, with a range from 1 to 9999 seconds.
The default is 3 seconds. You can update by distance, with a range from
0.01 to 9.99 mile/nm/km. The default is 0.10 miles.
With one of the Update Criteria selected, use the cursor arrows to
highlight either the
UPDATE RATE (TIME) or UPDATE DISTANCE data entry
boxes and press
ENT. Press ↑ or ↓ to change the first character, then
press
→ to the next character and repeat until the entry is correct.
Press
EXIT to return to the Trail Options Menu.
Update Time Rate (left) and Update Distance(right).
Specific Trail Options
Delete Trail
To delete a specific trail, from the Trails Menu, press ↓ to
Saved
Trails
|ENT. Select a trail and press ENT. The Edit Trail menu appears as
seen in the following figure. Press
→ to DELETE TRAIL|ENT|← to YES|ENT.