Filter
Top Products
90
2. PAGES – Pressing this and the ← → arrow keys switches the unit
between the four different page screens. (Satellite Status Page,
Navigation Page, Map Page and Sonar Page.) Each page represents one
of the unit's major operation modes.
3. MENU – Press this key to show the menus and submenus, which
allow you to select a command or adjust a feature. This also accesses
search functions for streets, intersections, addresses and highway exits.
4. ARROW KEYS – These keys are used to navigate through menus,
make menu selections, move the map cursor and sonar chart cursor and
enter data.
5. ENT/ICONS (Enter & Icons) – This key allows you to save data,
accept values or execute menu commands. It is also used to create
event marker icons.
6. EXIT – The Exit key lets you return to the previous screen, clear
data or close a menu.
7. WPT – (Waypoint) The Waypoint key is used to save, search and
recall waypoints. It not only gives you access to the waypoints list, but
also launches the Point-of-Interest (POI) search menus and is involved
in some navigation functions.
8. ZOUT – (Zoom Out) – This key lets you zoom out the map display.
On the Sonar Page, the
ZOUT key returns you to a full sonar chart
display, showing the entire water column from surface to bottom. On
the Map Page, it lets you see a larger geographic area on the map. Less
detail is seen as you zoom out.
9. ZIN – (Zoom In) – This key lets you zoom in on the map. On the
Sonar Page, it enlarges fish signals and bottom detail. On the Map
Page, zooming in lets you see greater detail in a smaller geographic
area on the map.
Power/lights on and off
To turn on the unit, press PWR. As the unit powers up, the Map Page is
displayed first. (To switch to another page, press
PAGES|← or → to
Page Name|
EXIT.)
To turn on the backlight, press
PWR again. The unit has three backlight
levels. Repeatedly pressing
PWR will cycle through the backlight
settings and turn off the backlight.
Turn off the unit by pressing and holding the
PWR key for 3 seconds.