Filter
Top Products
158
WARNING:
If you uncheck the Update Trail option, automatic trail
creation and recording will be turned off. You must turn
it back on to record trails. The default setting is on.
From the Trails Menu, press ↓ to
OPTIONS|ENT. With UPDATE ACTIVE TRAIL
highlighted, press ENT to turn it on (check) and turn it off (uncheck).
Update Trail Criteria (Auto, Time, Distance)
The options are automatic, time or distance. When it's in the default
automatic mode, the unit doesn't update the plot trail while you're
traveling in a straight line. Once you deviate from a straight line, the
unit drops a plot point (trail waypoint) onto the trail. This conserves
plot trail points. If a plot trail uses all of the available points allotted to
it, the beginning points are taken away and placed at the end of the trail.
From the Trails Menu, press ↓ to
OPTIONS|ENT|↓ to UPDATE CRITERIA.
Press ← → to select criteria type|
ENT.
Trail Update Rate (Time, Distance)
You can update a trail by time with a range of 1 to 9999 seconds. The
default is 3 seconds. You can update by distance with a range of 0.01 to
9.99 mile/nm/km. The default is 0.10 mi.
With one of the Update Criteria selected, use the cursor arrows to
highlight either the
UPDATE RATE or UPDATE DISTANCE data entry boxes and
press
ENT. Press ↑ ↓ to change the first character, then press → to the
next character and repeat until the entry is correct. Press
EXIT to re-
turn to the Trail Options Menu.
Update Time Rate setting (left) and Update Distance setting (center).
Edit Trail menu (right).