Filter
Top Products
67
3. The data begins to flash on your screen. Use ← →, ↑ ↓ to move the
data to a new location on the screen.
4. When satisfied, press
EXIT|EXIT.
NOTE:
The Customize command and the Overlay Data command both use
the same information categories. The difference between the two
commands is that Customize only changes data in digital data
boxes. The Overlay Data command changes information floating
freely on the screen.
To change displayed data font size:
1. Press MENU|↓ to OVERLAY DATA|ENT.
2. Press ↓ ↑ to desired data type, then press ← → to adjust data size.
The selected data type will be displayed in the new size.
To change the font size of another data type, repeat Step 2.
3. After the desired changes are made, end the command and return to
the previous page by pressing
EXIT.
Map Page showing boat cruising Puget Sound, Washington, with Over-
lay Data turned on (left). This example shows Depth, Ground Speed
and the Steering Arrow. The second figure (right) shows Depth,
Ground Speed and the boat's track.
NOTE:
Some data types can be displayed in only one font size. If that is the
case, the Data Size box will not be displayed for that data type.
Ping Speed & HyperScroll
Ping Speed controls the rate at which the unit broadcast sonar sound
waves — pings — into the water. The unit has a default ping speed of
Steering
arrow