Filter
Top Products
1. MOUNTING
1-5
2. Fasten the raise/lower drive assembly to the main body flange with the trunnion shaft.
Main body flange
Split pin
Raise/lower
drive assy.
Trunnion shaft
Flat washer
Flat washer
Passing main shaft through the raise/lower drive assy.
3. Coat the top of the main shaft with a small amount of grease. Pass the main shaft
through the main body flange, and fix it temporarily with the shaft retainer. (The shaft
retainer should be secure enough to prevent shaft rotation.)
Grease threads.
Main shaft should
protrude by 44 mm from
top of shaft retainer.
Wipe off grease before
tightening
shaft retainer.
Raise/lower
drive assy.
Main shaft
M10
M10 Spring washer
M10x40
44 mm
Passing main shaft through the raise/lower drive assy.
4. Tape the end of the transducer cable with vinyl tape to pass the cable through the main
shaft. Remove sheath of transducer cable by the length shown below with roller knife.
Note: Care should be taken not to damage inner wires when cutting the cable sheath,
only paper tape exists between the cable sheath and inner wires.
Use suitable roller
knife to cut sheath.
Main shaft length + 120 mm
L
Lower edge
of flange
Transducer cable