Filter
Top Products
1. MOUNTING
1-18
Changing the cable entrance location
1. Unfasten six screws (M4x8) at the bottom of the control unit.
2. Unfasten two screws (M4x10) fixing the cable clamp.
Discard these screws.
3. Unplug connectors from J1 and J2 on the KEY Board 10P6951.
Default hole location
*
**
*
*
Screws
M4X8 (6 pcs.)
J3
J1
J2
Remove this cable clamp.
Disconnect these connectors.
Control unit
4. Attach the cable clamp removed at step 2 with two screws, spring washers, flat washers
and nuts (supplied with accessories) to fix the control cable shown below.
Bottom chassis
Screw (M4X12)
Spring washer
Flat washer
Nut
Cable clamp
Fix the cable with cable clamp here.
Default hole location
Screws
M4X8 (6 pcs.)
Control head
5. Reattach connectors J1 and J2.
6. Fasten six screws to assemble the control unit.