Filter
Top Products
2. WIRING
2-9
Connecting contact pins
A special crimping tool is necessary for connection of wires to the contact pins of the 38P
connector. In addition, a pin extractor should be used to remove the contact pin from the
connector housing.
Crimping Tool
06-1001-016
Pin Extractor
06-1877-04
How to use the crimping tool
1. Strip the vinyl sheath of the wire to expose the core by 3.5 mm.
2. Hold the crimping tool horizontally and insert the contact pin with its slit facing downward
into the crimp hole on the crimping tool.
3. Insert the wire onto the contact pin and squeeze the handle until the ratchet releases.
(Place wire deep enough into the contact pin so that its end comes contact with the
stopper plate of the crimping tool.
4. With crimping completed, pull the wire while holding the contact pin to make sure that it
is fastened tightly.
How to insert contact pin