Filter
Top Products
1. MOUNTING
1-17
300 + 1
KB fixing plate
Tapping screw
(φ6.5)
Hex. bolt
(M5X12)
How to attach KB fixing plate
Installation without KB fixing plate
1. Make four holes of 6 mm in diameter referring to the figure below.
Control unit, dimensions for directly mounting
2. Make an indentation in the desktop to accommodate the nameplate (approx. 2 mm
thickness) at the bottom of the control unit.
3. If necessary, make a hole 30 mm in diameter in the tabletop to pass the control cable
from the bottom of the control unit. To run the able from the bottom of the control unit,
see the next page.
4. Screw in four hex. bolts (M5x12, supplied as accessories) from the under side of the
table to fix the control unit.
When the above bolts are not long enough, use locally supplied bolts, with their length the
thickness of the desktop plus 5 to 8 mm.
Mounting control unit directly