Filter
Top Products
1. BASIC OPERATION
1-20
Entering character
SELECT ALPHANUMERIC CHARACTER BY TRACKBALL AND PRESS KNOB
TO ENTER. OR PRESS NUMERIC KEY TO NAME WAYPOINT.
MOVE THE CURSOR TO "END" ONCE THE EDITION IS FINISHED.
END
ABCDE FGHIJ KLMNO PQRST UVWXY
Z,-!? /&^=# 12345 67890 _____
abcde fghij klmno pqrst uvwxy
z____ _____ _____ ______ ___
PASSWORD ENT AGAIN
Digit cursor Cursor
Ex. Set password, entering characters
1. Roll the trackball in up-down direction to select the first alphanumeric
character with the cursor (red square).
Numeric may also be entered by pressing numeric key.
2. Press the [ENTER] knob.
Note: If you enter a wrong character, move the cursor to that location and then
re-enter the proper character. To move the digit cursor, select ◄ and then
press the [ENTER] knob for left direction, or select ► and then press the
[ENTER] knob for right direction.
Press the [CLEAR] key to erase the all characters.
3. Repeat steps 1 and 2 to complete the naming.
4. Finally, select "END" and then press the [ENTER] knob.