Filter
Top Products
3. TRACKS
3-14
3.5.2 Track plotting interval
The track plotting interval can be changed as you like.
1. Press the [MENU] key to show the main menu.
2. Press the [4] key to show the MARKS/SHIP’S TRACKS SETUP menu.
3. If PAGE 2/2 appears, rotate the [ENTER] knob to select PREVIOUS PAGE.
4. Rotate the [ENTER] knob to select “TRACK INTERVAL 1” or “TRACK
INTERVAL 2”.
5. Roll the trackball in left-right direction to select “TIME” or “DIST (distance)” as
appropriate.
6. Press the numeric keys to enter value.
Setting range is 00M00S to 99M59S (Time), 0.00 nm to 9.99 nm (Distance).
Note 1: To clear data, press the [CLEAR] key.
Note 2:You may remove a plotting interval from the [PLOT INTVL] key’s
selection sequence by entering all zeroes as the plotting interval. For
example, if TRACK INTERVAL 2 is set as 00M00S (or 0.00 nm), the
sequence [PLOT INTVL] key’s sequence is as shown below.
TRACK INTERVAL 1 → Hold → TRACK INTERVAL 1 → Hold
7. Press the [ENTER] knob.
8. Press the [MENU] key several times to close the menu.