Filter
Top Products
Install the GracoConfig Software
312785C 13
Load the Software
1. Connect the USB cable (23, supplied) between the
USB port on the Gateway module and a USB port
on your PC. See F
IG. 12.
2. F
IG. 13 will appear. Select “Yes, this time only”, then
click Next.
3. F
IG. 14 will appear. Insert the CD in your PC’s
CDROM drive. Select “Install the software from a list
or specific location”, then click Next. The program
location is C:\Program Files\Graco\GracoCon-
fig\Device.
NOTE: The name of the driver may be different. Just
accept the name and proceed by following the
instructions on the screen.
Software Updates
Contact your distributor or Graco Technical Assistance
for software updates.
F
IG. 12: Gateway Module USB Port
F
IG. 13: Found New Hardware Screen
TI12930a
USB Port
USB Cable Strain Relief
FIG. 14: Load Software from a Specific Location