Filter
Top Products
Install the Gateway Module Hardware
312785C 7
Connect the Module to the
EasyKey
FIG. 1 is only a guide showing installation of the Graco
Gateway in a ProMix 2KS System; it is not a complete
system design, Contact your Graco distributor for assis-
tance in designing a system to suit your particular
needs.
1. Shut off ProMix 2KS power (0 position). F
IG. 2. Also
shut off power at main circuit breaker.
2. Connect a 2-wire twisted pair cable with shield wire
from the EasyKey connector to the connector on the
Gateway module. Connect a communications
wire/cable (protocol dependent) from the Gateway
module to the PLC. See F
IG. 3.
NOTE: Graco provides expansion cards for DeviceNet
and Profibus protocols. DeviceNet setup procedures are
on page 42. Profibus setup procedures are on page 57.
See page 40 for Parts.
NOTE: If using the Graco Gateway in your system, dis-
connect its cable from the EasyKey before updating the
ProMix 2KS software.
Cabling Connections
See FIG. 4 and FIG. 5 for typical cable connections in a
ProMix 2KS system.
F
IG. 6 through FIG. 9 show other possible cable connec-
tions.
F
IG. 2: Power Off
0 = OFF
TI12657a