Filter
Top Products
Appendix A: DeviceNet
™
Slave Communication
52 312785C
Configure the RSNetWorx for DeviceNet Software
RSNetWorx for DeviceNet is used to set up and manage
a DeviceNet network. To begin the configuration, launch
RSNetWorx for DeviceNet from your development PC.
Start a new network by selecting: File>New>DeviceNet
Configuration.
Register the EDS file generated by Gateway as shown
in the previous section of this document by selecting:
Tools>EDS Wizard>Register an EDS file(s).
Select Register a single file, and browse to the location
where you saved the Gateway.EDS file.
Make sure that the .EDS file validation is successful.
If desired, select a new image file to represent the Gate-
way.
F
IG. 38: Register the EDS File
F
IG. 39: Browse to Graco Gateway EDS File
FIG. 40: EDS Validation
F
IG. 41: EDS Image File