Filter
Top Products
Working Inside the System 29
Installing the IDE Drive Bay
1. Observe the safety and ESD precautions at the beginning of this chapter.
2. Place the drive bay into the chassis so its hinges are in their slots.
3. Move the drive bay down until the screw holes in the bay and the chassis line up.
4. Replace the two screws on the top of the bay (see Figure 17, C).
OM07560
A
B
C
Figure 17. Disconnect Cables and Remove Screws
A. Power cable
B. Data cable
C. Screws
5. Replace the screw in the flange at the bottom of the drive bay (see Figure 8, A, on page 20).
6. Connect data and power cables to any drives in the bay.