Filter
Top Products
42 Intel Astor II Server Chassis Subassembly Product Guide
Hot-swap Backplane
Removing the SCSI Backplane
1. Remove any hard drives installed in the hot-swap bay.
2. Remove the hot-swap bay from the chassis.
3. Remove the hot-swap bay fans.
4. Remove the four corner screws holding the plastic shroud and SCSI backplane to the hot-swap
bay. Do not remove the two center screws.
OM07042A
A
A
A
A
B
Figure 27. Removing the Plastic Shroud
A. Screws
B. Threaded tabs on hot-swap bay
5. Remove the plastic shroud and set it aside.
6. Remove the two center screws holding the SCSI backplane to the hot-swap bay.
7. Remove the SCSI backplane, and place it component side up on a nonconductive, static free
surface or in an antistatic bag.