Filter
Top Products
Working Inside the System 41
Removing a Hot-swap Bay Fan
OM07042
A
Figure 26. Removing the Hot-swap Bay Fan Bracket
1. Observe the safety and ESD precautions at the beginning this chapter.
2. Remove the side cover.
3. Disconnect the fan’s power cable from the SCSI backplane.
4. Snap the fan out of the plastic shroud.
Installing a Hot-swap Bay Fan
1. Position the fan, label side facing away from the hot-swap bay, and snap it into the shroud.
2. Connect the fan’s power cable to the SCSI backplane (a fan in the bottom of the shroud
connects to the Fan 1 header; a fan in the top of the shroud connects to Fan 0 header).
3. Reinstall the side cover.