Filter
Top Products
Working Inside the System 43
OM07053
A
A
Figure 28. Removing the SCSI Backplane
A. Screws
Installing the SCSI Backplane
1. Place the SCSI backplane component side to the hot-swap bay.
2. Insert and tighten the two center screws that hold the backplane to the hot-swap bay.
3. Place the plastic shroud on the back of the backplane.
4. Insert and tighten the four corner screws holding the plastic shroud and SCSI backplane to the
hot-swap bay.
5. Install two hot-swap bay fans.