Filter
Top Products
E6581090
D-7
4
■How to use the wizard function
Here are the steps to follow to set parameters, using the wizard function. (When the basic setting
wizard (CWH) is set to 1)
Key operated LED display Operation
Displays the operation frequency (operation stopped).
(When standard monitor display selection H= is set to
0 [operation frequency]).
CWJ
The first basic parameter "History (CWJ)" is displayed.
CWH
Select the wizard function (CWH) by pressing the △ or ▽
key.
Press the ENTER key to confirm your choice. is displayed.
Switch to purpose-specific wizard by pressing the △ or ▽
key.
EOQF
Press the ENTER key to confirm your choice. The first
parameter in the purpose-specific wizard parameter group is
displayed. (See Table below)
＊＊＊＊
After moving to the purpose-specific wizard parameter group,
change the setting of each parameter by pressing the △ or ▽
key and the ENTER key.
GPF
GPF is dialyzed on completion of the setting of the wizard
parameter group.
Display of
parameter
↓
CWH
↓
HTH
↓
Press the MON key to exit the wizard parameter group.
By pressing the MON key, you can return to the default
monitoring mode (display of operation frequency).
Table of parameters that can be changed using the wizard function
Basic setting wizard Preset-speed setting wizard
Analog input operation
wizard
Motor 2 switching operation
wizard
To r que UP wizard*
EOQF
HOQF
CEE
FGE
HJ
WN
XN
H
EOQF
HOQF
CEE
FGE
HJ
WN
H
H
H
H
H
H
UT
UT
UT
UT
UT
UT
UT
H
H
H
H
H
H
H
H
EOQF
HOQF
CEE
FGE
HJ
WN
NN
H
H
H
H
H
H
H
H
H
XN
H
XD
H
VJT
CEE
FGE
H
H
H
H
H
H
XN
RV
H
H
H
H
*This parameter is valid only for VFNC1 (S)-□□□□P□-W type.
ENT
▲
▼
ENT
▲
▼
MON
MON
MON
▲
▼
MON
If there is anything you do not understand during this operation, press the key several
times to start over from the step of CWJ display.
JGCF or GPF is affixed respectively to the first or last parameter in each wizard parameter group.
MON