A SERVICE OF

logo

Dynamic ARP Inspection Commands 279
Example
console(config-if-1/g1)#ip arp inspection limit none
console(config-if-1/g1)#ip arp inspection limit rate
100 burst interval 2
ip arp inspection trust
The ip arp inspection trust command configures an interface as trusted for
Dynamic ARP Inspection. Use the “no” form of this command to configure
an interface as untrusted.
Syntax
ip arp inspection trust
no ip arp inspection trust
Default Configuration
Interfaces are configured as untrusted by default.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-1/g3)#ip arp inspection trust