560 Spanning Tree Commands
spanning-tree portfast default
Use the spanning-tree portfast default command to enable Portfast mode
only on access ports. Use the “no” form of this command to disable Portfast
mode on all ports.
Syntax
spanning-tree portfast default
no spanning-tree portfast default
Default Configuration
Portfast mode is disabled by default.
Command Mode
Global Configuration mode
Usage Guidelines
There are no usage guidelines for this command.
Example
The following example enables Portfast mode on all ports.
console(config)#spanning-tree portfast default
spanning-tree port-priority
Use the spanning-tree port-priority command in Interface Configuration
mode to configure port priority. To reset the default port priority, use the no
form of this command.
Syntax
spanning-tree port-priority
priority
no spanning-tree port-priority
•
priority
— The port priority. (Range: 0–240)
