838 Multicast Commands
Default Configuration
There are no static RP addresses configured by default.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(config)#ip pimsm rp-address 192.168.20.1 225.1.0.0
255.255.255.0
ip pimsm rp-candidate
The ip pimsm rp-candidate command is used to configure the router to
advertise itself as a PIM candidate rendezvous point (RP) to the bootstrap
router (BSR). Use the “no” form of this command to disable the router to
advertise itself as a PIM candidate rendezvous point (RP) to the bootstrap
router (BSR). This command deprecates the ip pimsm crppreference
command.
Syntax
ip pimsm rp-candidate vlan
vlanid group-address group-mask
ip pimsm rp-candidate vlan
vlanid
•
vlanid
— A valid VLAN ID.
•
group-address
— Group IP address supported by RP.
•
group-mask
— Group subnet mask for group address.
Default Configuration
The router does not advertise itself as a PIM candidate rendezvous point by
default.
Command Mode
Global Configuration mode
