IPv6 Routing Commands 797
Router Advertisement Suppress Flag............. Disabled
Prefix 3FF0:1236:C261::1/64
Preferred Lifetime............................. 10000
Valid Lifetime................................. 100000
Onlink Flag.................................... Enabled
Autonomous Flag................................ Enabled
console#show ipv6 interface brief
Oper.
Interface Mode IPv6 Address/Length
---------- -------- ---------------------------------
vlan3 Enabled FE80::2FC:E3FF:FE90:147/128
3FF0:1236:C261::1/64
loopback 1 Enabled FE80::2FC:E3FF:FE90:145/128
3FF0:C221:1234::1/64
loopback 2 Disabled
tunnel 1 Disabled 3FFE:1234::1/64 [TENT]
show ipv6 mld groups
The show ipv6 mld groups command is used to display information about
multicast groups that MLD reported. The information is displayed only when
MLD is enabled on at least one interface. If MLD was not enabled on any
interfaces, there is no group information to be displayed.
Syntax
show ipv6 mld groups {
group-address
| vlan
vlan-id
}
•
group-address
— The group address to display.
•
vlan-id
— A valid VLAN id.
